ThenĬonfigure options to match your silicon and the board Say Y here if your system has a dual role high speed USBĬontroller based on the Mentor Graphics silicon IP. Tristate 'Inventra Highspeed Dual Role Controller (TI, ADI, AW. Musb_hdrc load is successful.BUT when I connect my USB drive to USB port my USB drive not mount in /media also not show me at /dev why ? am I missing something ? also i check Kconfig file config USB_MUSB_HDRC Libcomposite 42715 16 usb_f_rndis,usb_f_ecm Now run "modprobe musb-hdrc" command and write "musb_hdrc" vi /etc/modules-load.d/nfĪbove command run successfully and not see any errorĪfter that reboot, the board run "lsmod" command to the sure module is load or not lsmod directory ls /lib/modules/4.4.16/kernel/drivers/usb/musb/musb_hdrc.ko I load new zImage and /lib/module/4/4/16 to my board and found. My usb drive not work on my device so I make module 'm' for Inventra Highspeed Dual Role Controller and generate musb-hdrc.ko file I found that when i uncheck Inventra Highspeed Dual Role Controller (TI, ADI, AW.
The reason is I want to make module of USB storage driver so i can install module first to connect my usb drive to the device Note= am335x_fujitel_defconfig is my edited defconfig file according to my bord and after that type Make am335x_fujitel_defconfig CROSS_COMPILE=arm-linux-gnueabihf.
and also have kernel source code and version is 4.4.16 now i follow the command to compile kernel source code make distclean CROSS_COMPILE=arm-linux-gnueabihf. I have one customized bord using an am335x processor and this board has one USB port(for USB drive connector) and one micro USB port. I want to loard a usb drive storage module so i make when i load usb mass storage module the usb drive detect in /media or /dev/sda1
0 kommentar(er)
